Категории
Sensoriga kontaktivaba segisti Presto2.png Zoom

Смеситель на раковину с инфракрасным сенсором PRESTO LINEA

Артикул: P57212
Бренд:
Единица: шт
Время доставки: 7-14 дней
Цена: 623,00 €
591,85 €
Kuumakse alates: 50,31 €
Кол-во: - +
   - или -   

Смеситель на раковину с инфракрасным сенсором PRESTO LINEA

Valamusegisti kontaktivaba IR sensoriga PRESTO LINEA

Range: PRESTO LINEA®
Ref: 57212 - Deck-mounted sensor mixer tap for washbasin, battery, 3l/min with stop valve

> Working pressure:

1 to 5 bar

> Function:

Starts and stops automatically by hand detection
Sensor trigger suitable for PRM, elderly, children and disabled people

> Flow:

3l/min at 3 bar with integrated regulated anti-limescale aerator

> Hydraulic supply:

F G 3/8" (12x17) hoses

> Power supply:

Integrated 3V CR123A lithium batteries (x2)

> Material and colour finish:

Chrome-plated brass body with smooth inside body Chrome-plated molded metal cover

> Thermal resistance:

Resistant to a temperature of 75°C for 30-minute-thermal-shocks

> Security:

Anti-overflow security time set to 30 seconds preventing the water to flow continuously Automatic shutdown of solenoid valve in case of low battery or sensor damage
Duty flush 30 sec every 24h after last use (adjustable flow time and frequency)
Low battery alert (blinking led light)

Maximum temperature limitation with adjustable temperature stop

> Installation:

Recommended installation : 30 cm minimum between the sensor and the basin

> Delivered with:

1 Brass clamping nut, 1 Gasket and 1 Washer
2 PEX hoses with revolving nuts, NF check valves and filter gaskets 2 M M G 3/8" (12x17) stop valves
1 Self-adhesive sticker
1 Instruction manual

> Standards & approvals:

Brass body in accordance with NF EN1982, EN12164, NF EN 12165,

UBA list compliant

200-hour neutral salt spray resistant (NSS) in accordance with NF ISO 9227

 

 

 

 

 

 

Файлы

Схожие продукты
Артикул: D7667400 ,   Время доставки: 7 дней
57,00 €

Vajutava nupuga segisti 

Presto

Antiblokeerimise süsteemiga

kroom

15 sek. töötsükkel 3 bar

3-6 l/min

Артикул: P68132 ,   Время доставки: 7 дней
395,20 € (5%)
416,00 €
Артикул: P63210 ,   Время доставки: 7-14 дней
186,20 € (5%)
196,00 €

Peitsegisti 30 sek töötsükkel

Артикул: P35941 ,   Время доставки: 7-14 дней
624,15 € (5%)
657,00 €
Антивандалльная душевая пьезо кнопка Н/Р сталь, для смешанной воды,  без адаптора
 
 

AUS 11

Pressure button-controlled shower for heat regulated water

 

 

   
 
 
 

AUS 11 is a new type of shower fitting for single shower control. The fitting is designated for premixed water – with one water inlet and shower outlet elbow. Water is released and closed by an anti-vandal pressure button connected to electronics and an electromagnetic valve. The fitting is covered by a rust-free anti-vandal cover to prevent damage. 

The mounting system has been designed so as to make removing the cover without using tools impossible with no bolt or screw being visible. The cover can be "pushed into" the wall level even if the mount box has been walled to an incorrect depth. 

AUS 11 is identical to AUS 1P with a different design and very resistant cover sheet. 

Electronics can work in two modes: 

1) The button works on the START/STOP basis – water release/closing. If the water is not turned off upon the time adjusted by the user or manager (e.g. 20 seconds), the electronic system itself instructs water stopping. The user must press again to start water running. This significantly saves water as the user reduces the showering time. 

2) The button works on the START/STOP basis. After the time adjusted by the manager (e.g. 3 minutes) expires there is a forced break when water cannot be released. During this time, the user is forced to leave the shower or wait. This prevents needless showering – water wasting. 

 

 
Basic technical information
Water input: G 1/2“
Water pressure: 1 - 10 Bar (0,1 – 1,0 MPa)
Time of water flow: 10 s – 42,5 min in mode 1
  0 s - 42,5 min in mode 2
Power supply: 12 V, 50 Hz
Power requirement: 6 VA
Source of power supplz: ZAC 1/20 (max. 3× AUS 11)
  ZAC 1/50 (max. 8× AUS 11)
Weight: 2,0 kg
 
 
Requirements for setting up the construction
  1. Water installation set up as per picture
  2. Set-up alcove 150 x 75 mm for installation casket
  3. Set-up cable for power supply – 12 V, 50 Hz from source of power supply ZAC
 
 
Complete delivery
  • installation casket
  • input and output bolting
  • electromagnetic valve
  • spherical valve
  • covering metal plate with piezo button
  • electronics
 
 
Made to order
  • SP 1 – shower arm with water flow of 9 l/min
  • SP 2 – shower arm with water flow of 7 l/min
  • SP 3 – shower arm with water flow of 7 l/min
  • ZAC - source of power supply 12V, 50Hz
 
 
Figure
 
 
A - water inlet G 1/2"
C - electricity supply cable 12 V, 50 Hz 
G - water outlet into shower armG 1/2"
 
 
 
 
Download information about the product
AUS 11 data for projectants - ( 84 kB )
 
Артикул: AZP-AUS 11 ,   Время доставки: 3-4 недели
375,00 €