Delabie GROUP termostadi ventiil 3/4" PREMIX SECURITY 55L 44°C to 58°C 731052
Kaubamärk:
Ühik: tk
Tarneaeg: 14-21päeva
‼️ Kasuta promokoodi TALV2026 ostukorvis ja saa soodustust – ainult täna!
✅ Populaarsed tooted Tallinna laos kohe olemas — tarneaeg 1–3 päeva või tule ise järele.
✅ Kui toode on tellimisel, uuri lähemalt — saame tihti pakkuda oodatust kiiremat tarnet: info@pegu.ee
✅ Kõikidele toodetele garantii 2 aastat ja 14‑päevane tagastusõigus.
✅ Automaatne arve e‑postile. E‑arve soovijatel palume lisada märge kommentaaridesse.
ℹ️ Hind sisaldab käibemaksu.
Delabie GROUP termostadi ventiil 3/4" PREMIX SECURITY 55L 44°C to 58°C 731052
PREMIX SECURITY
Ref. 731052
Group thermostatic mixing valve for hot water circulating loops adjustable from 44°C to 58°C:
Anti-scalding safety.
Regulates temperature variations.
Non-return valves and filters accessible from the exterior without having to remove the mechanism.
Thermal cartridge with no specific lever needed (push-button on the control knob).
Interchangeable cartridge with thermostatic cell.
High-resistance chrome-plated brass body.
Maximum hot water temperature: 85°C.
Differential hot water / mixed water: 15°C mini.
Pressure differences at the entrance: 1 bar maximum (0.5 bar recommended).
Minimum pressure / maximum: 1 to 10 bar (1 to 5 bar recommended).
Left hand side hot water inlet (red ring) and right hand side cold water inlet (blue ring).
Mixed water outlet at the top (purple ring) for bottom outlet: unscrew / place lid at the top and outlet connector at the bottom.
15% energy savings: optimised heat loss (comparison between a circulating loop at 55°C and a non-circulating system at 70°C).
Safety and prolongation of system life span (Hot water at > 65°C leads to premature aging within the system).
Maximum temperature limiter, can be adjusted by the installer.
Reduced risk of scalding by limiting temperature at the point-of-use.
55 lpm - M3/4".
Failid
Kraanikaussi segisti isesulguv, 15sek 3bar, antibock PRESTO
68132
Vajutava nupuga segisti
Presto
Antiblokeerimise süsteemiga
kroom
15 sek. töötsükkel 3 bar
3-6 l/min
Joogifontaan, 3/8" keere 312QU1
MORA külmumisvastane aiakraan 1000mm, võti+vaakumklapp 461760
MORA GARDEN - Frost-proof garden valve
Our garden valves are self-draining and therefore frost-proof even if you forget to dismantle the garden hose before the season with degrees below zero. However, we recommended that you always remove the hose and coupling when there is a risk of low temperatures.
DescriptionFor wall thickness max. 1000 mm
Article number 461760
PROPERTIES
- Self-draining
- Key included
- With approved non-return valve
- Can be cut to suit wall thickness
- Wall bracket: H=110 mm, W=60 mm
- Approved backflow prevention device, EN-Standard EN 1717
Sensoriga kraan Sanela R/V teras, külma/ellsegatud veele SLU 45, 24V DC
Characteristics
- economical aerator, rate of flow 6 l/min
- function of automatic water stop after 5 minutes of continuous flow
- water is flowing as long as hands are in the active range (max. range to 0,3 m)
- water stops flowing after removal of hands from the active range of sensor after adjustable time delay from 0,25 to 7,75 sec
- possibility of changing of time delay, active range and switching off by SLD 03
- SLU 45 is destined for cold or premixed water under the washbasin
- START/STOP program
Valamu antivandaalne komplekt 1-200mm seinale 31660
31660
> Working pressure : 1 to 5 bar
> Flow : 6 l/min at 3 bar - 4-position flow adjustment device Anti-water-hammering design
> Flow time : 15 seconds (± 5 sec.)
> Hydraulic supply : In-line water inlet M G 1/2" Inlet and outlet Cold water
> Thermal resistance : Resistant to a temperature of 75°C for 30 minute thermal shock
> Security : Patented anti-blocking "S" system to avoid the water to flow continuously
> Delivered with : 1 Cross-partition control (1 to 200 mm thick) 1 Short wall spout (Non-rotating fixing) 87 mm 1 Closing tap with S anti-blocking system 1 stop valve M 1/2" (15x21) / M 1/2" (15x21) with quick couplings (12x14 mm) Instruction manual
> Standards & approvals : Brass body in accordance with EN 1982, EN 12164, EN 12156 Molded chrome-plated body in accordance with EN 12540 200-hour neutral salt spray resistant (NSS) in accordance with ISO 922
