Deck-mounted electronic basin mixer: 
Independent IP65 electronic control unit. 
123 6V Lithium battery-operated. 
Flow rate pre-set at 3 lpm at 3 bar, can be adjusted from 1.5 to 6 lpm. 
Scale-resistant flow straightener. 
Adjustable duty flush (pre-set flush ~60 seconds. every 24hr after last use). 
Active, infrared presence detection, sensor at the end of the spout optimises detection. 
Chrome-plated brass body. 
PEX flexibles with filters and solenoid valves M3/8". 
Fixing reinforced by 2 stainless steel rods. 
Anti-blocking safety. 
Spout with smooth interior and low volume of water(reduces niches where bacteria can develop). 
Side temperature control with standard lever control and adjustable maximum temperature limiter.
Suitable for people with reduced mobility.

TECHNICAL FEATURES 

BINOPTIC MIX electronic mixer 
Ref. 478MCH

Group thermostatic mixing valve for hot water circulating loops adjustable from 44°C to 58°C: 
Anti-scalding safety. 
Regulates temperature variations. 
Non-return valves and filters accessible from the exterior without having to remove the mechanism.
Thermal cartridge with no specific lever needed (push-button on the control knob). 
Interchangeable cartridge with thermostatic cell. 
High-resistance chrome-plated brass body. 
Maximum hot water temperature: 85°C. 
Differential hot water / mixed water: 15°C mini. 
Pressure differences at the entrance: 1 bar maximum (0.5 bar recommended). 
Minimum pressure / maximum: 1 to 10 bar (1 to 5 bar recommended). 
Left hand side hot water inlet (red ring) and right hand side cold water inlet (blue ring). 
Mixed water outlet at the top (purple ring) for bottom outlet: unscrew / place lid at the top and outlet connector at the bottom. 
15% energy savings: optimised heat loss (comparison between a circulating loop at 55°C and a non-circulating system at 70°C). 
Safety and prolongation of system life span (Hot water at >65°C leads to premature aging within the system). 
Maximum temperature limiter, can be adjusted by the installer. 
Reduced risk of scalding by limiting temperature at the point-of-use. 
90 lpm - M1".